TransAct Technologies ITHERM 280 - Manual (Page 166)

Programming Codes iTherm ® 280 Programmer’s Guide
Page 164 Rev C 28-07764
[BEL] Audio alert
ASCII
[BEL]
Hexadecimal 07H
Decimal
<7>
IPCL &%BL
EPOS [BEL]
Description When enabled, the [BEL] command starts the audio alert sequence. The
default is a single sound, lasting the period of time defined by the audio
alert setting. If the audio alert is off, it does not function.
[ESC] [BEL] Configure audio alert
ASCII
[ESC] [BEL]
1
>
2
>
3
>
Hexadecimal 1BH 07H
1
>
2
>
3
>
Decimal <27> <7>
1
>
2
>
3
>
IPCL None
EPOS None
Description The [ESC] [BEL]
1
>
2
>
3
> command alters the way the audio alert
sounds.
The default is a single sound lasting the period of time defined by the audio alert setting.
The [ESC] [BEL]
1
>
2
>
3
> command allows the sound to be
altered.
Where is the number of alert cycles
is the on time of the alert cycle in ten Ms intervals
is the off time of the alert cycle in ten Ms intervals
[ESC] p 5 Enable/disable paper feed
ASCII
[ESC] p 5
Hexadecimal 1BH 70H 35H
Decimal
<27> <112> <53>
Range 0
≤
n
≤
255
Description The [ESC] p 5 command enables or disables the FEED button. When
the least significant bit (LSB) of = one, the FEED button is disabled;
when it is zero, the button is enabled. To prevent problems caused by
accidentally pressing the
FEED button, use the command to disable it.
The FEED button is temporarily enabled, regardless of how the command
is set during the wait time set by the [GS] z 0 command for paper
insertion and during the recovery confirmation time.
Where Bit 0 = 1 the FEED button is disabled
Bit 0 = 0 the button is enabled.