TransAct Technologies ITHERM 280 - Manual (Page 69)

Configuring Your ITherm ® 280 Printer iTherm ® 280 Programmer’s Guide
28-07764 Rev C Page 67
Smoothing Flag for whether scaled
characters smoothed. Enabled, Disabled Enabled
Paper Width Width of the paper
installed. 80 or 58 mm paper and
print zone from 608 to
256 dots 80 mm and 576 dots.
Bar Code Width Default barcode line
width. 1 to 8 3
10CPI (DC2)
ESC v
nINIT/ENQ<10>
Carriage Return This option defines how
CR and LF characters
are used. Normal, Ignore LF,
Ignore CR ,
Add LF to CR,
Add CR to LF,
Add to Both,
Use CR as Print Ithaca Emulation:
Normal
Epson Emulation: Ignore
CR.
Axiohm Emulation: Use
CR as Print.
Off-Line Option This option defines what
conditions place the
printer off line. Normal: Cover open,
paper out, and buffer
full.
Buffer full only. Normal.
Line Spacing How many lines per inch
are printed by default. 6, 7.5, or 8 lines per
inch. Ithaca Emulation: 8
Most others: 6
Input Buffer This option specifies
how large the input
buffer is. 40 Characters
256 Characters
1024 Characters
2048 Characters
4096 Characters
8192 Characters
One Line 8192 Characters
Print Energy Control
Paper
This option will select a
paper type by brand
name. Generic Black
Generic Color
Custom Black
Custom Color
Optima POS
Kanzaki P-320
Kanzaki P-350
Kanzaki P-320RB
Kanzaki P-320GB
Kanzaki P-320BB
Appleton RB100-2.3
Appleton GB100-2.3
Appleton BB100-2.3
Generic Black
PreHeat Temp. This sets the
temperature that the pint
head tries to maintain. See the section on Head
pre-heat later in the
manual. 25
Power Supply The printer uses an 80W
internal supply. If an
external supply is used,
this adjustment will limit
the printer to the power
indicated. 60 to 120 Watts 80
Page Length This options sets the
default form feed page
length. 0 – 60 lines.
0 disables the form feed 40
Cash Drawer CMD The Microline option has
two potential cash
drawer commands ESC +
BEL BEL