TransAct Technologies ITHERM 280 - Manual (Page 223)

iTherm ® 280 Programmer’s Guide Programming Codes
28-07764 Rev C Page 221
1 6 Codabar 1
≤
k 48
≤
d
≤
57, 65
≤
d
≤
68
d = 32, 36, 37, 43, 45, 46, 47, 58
2 65 UPC A 11
≤
k
≤
12 48
≤
d
≤
57
2 66 UPC E 11
≤
k
≤
12 48
≤
d
≤
57
2 67 JAN-13 (EAN-13) 12
≤
k
≤
13 48
≤
d
≤
57
2 68 JAN-8 (EAN-8) 7
≤
k
≤
8 48
≤
d
≤
57
2 69 Code 39 1
≤
n
≤
255 48
≤
d
≤
57, 65
≤
d
≤
90
d = 32, 36, 37, 43, 45, 46, 47
2 70 ITF 1
≤
n
≤
255
(even number)
48
≤
d
≤
57
2 71 Codabar 1
≤
n
≤
255 48
≤
d
≤
57, 65
≤
d
≤
68
d = 32, 36, 37, 43, 45, 46, 47, 58
2 72 Code 93 1
≤
n
≤
255 0
≤
d
≤
127
2 73 Code 128 2
≤
n
≤
255 0
≤
d
≤
127
Table 42 Bar Code System Based on
[Description for
1
]
indicates the character code to be printed. A null (00 Hex) character ends
the bar code definition.
[Description for 2 ]
indicates the number of bytes of bar code data to be processed immediately
following . Additionally, indicates the character code to be printed.
The following apply to both
GS k
GS k
If the horizontal width exceeds the printing area, the printer only feeds the paper.
These commands feed as much paper as necessary to print the bar code
according to the GS h command. These commands are enabled only when no
data exists in the print buffer. When data does exist in the print buffer, the printer
processes the data following as normal data. After printing a bar code, the
print position is set at the beginning of the line. These commands are not
effected by print modes (emphasized, underline, character size, etc.)
Note: Barcode 39 allows the “*” character to be used as a start and stop
flag. If the “*” is used, the length specified must be at least as long as the
desired barcode.
Function Set Bar Code Height
ASCII GS h
Hexadecimal 1DH 68H
Decimal
<29> <104>
Range 1
≤
n
≤
255
Default 0.90 inch high
Description The GS h command sets the height of the bar code. The bar code height is
set to n/180 inch.
Function Select Printing Position of HRI Characters
ASCII GS H
Hexadecimal 1DH 48H