TransAct Technologies ITHERM 280 - Manual (Page 87)

iTherm ® 280 Programmer’s Guide Programming Codes
28-07764 Rev C Page 85
Vertical Motion Control
[ESC] j Perform a fine line feed
ASCII
[ESC] J
Hexadecimal 1BH 4AH
Decimal
<27> <74>
IPCL &%FM
1
>
2
>
3
>
EPOS [ESC] J
Description The [ESC] J command prints the contents of the buffer and performs
a line feed of n/216 inch. The default line spacing value is not changed.
The next character print position is reset to the left margin if the Auto-CR
mode is set.
Notes:
•
In EPOS mode, the command performs feeds in n/144-inch
increments.
•
Immediately after APA graphics, the command is adjusted for the
difference between 72 dpi graphics and 96 dpi print.
[ESC] 3 Set variable line spacing to n/216 inch
ASCII
[ESC] 3
Hexadecimal 1BH 33H
Decimal
<27> <51>
IPCL &%SV
EPOS [ESC] 3
Description The [ESC] 3 command sets the default line spacing to n/216 inch.
Set n = 1 to 255. The line feed spacing used by [LF] is set to values other
than 1/8 or 7/72 inch. The command takes effect immediately.
Note: In EPOS mode, the command performs line feeds in n/144-inch
increments.