TransAct Technologies ITHERM 280 User Manual
Page 167
iTherm
®
280 Programmer’s Guide
Programming Codes
28-07764
Rev C
Page 165
[ESC] p 4
Select paper sensor(s) to stop printing
ASCII
[ESC] p 4
Hexadecimal 1BH 70H 34H
Decimal
<27> <112> <52>
Range
0
≤
n
≤
255
Description The [ESC] p 4
stop printing. The default setting occurs when only the Paper Out sensor
stops printing. When the paper roll near-end sensor is enabled and the
sensor detects a near-end condition during printing, the printer completes
the current line and then automatically goes off-line. Replacing a new
paper roll restarts the printing. When the paper roll near-end sensor is
disabled and a paper near-end condition is detected during printing, the
paper out LED comes on, but the printer continues to print.
Note: The ITherm
®
does not allow the Paper Out sensor to be disabled. It
is always on.
Bit
On/Off
Hexadecimal
Decimal
Function
0,1
Off
00H
<0>
Paper roll near-end sensor disabled
On
01H,02H,03H
<1>,<2>,<3>
Paper roll near-end sensor enabled
7
-
00H
<0>
Undefined
Table 14 Paper Sensor Commands
[ESC] p 3
Select paper sensor(s) to output paper-end signals
ASCII
[ESC] p 3
Hexadecimal 1BH 70H 33H
Decimal
<27> <112> <51>
Range
0
≤
n
≤
255
Description The [ESC] p 3
paper-end signal to the parallel interface when a paper-end is detected.
The default setting is when all sensors are enabled. (
possible to select multiple sensors to output signals. If any of the sensors
detect a paper end, the paper end signal is output. The command is only
available with a parallel interface. The paper-end sensor is an option. If
the sensor is not equipped, the settings of bits 0 and 1 of the command
are not effective.