TransAct Technologies ITHERM 280 - Manual (Page 70)

Configuring Your ITherm ® 280 Printer iTherm ® 280 Programmer’s Guide
Page 68 Rev C 28-07764
CD ESC BEL Parm. The Microline Emulation
has the option of using
the ESC BEL command
to operate the cash
drawer Enabled
Disabled Disabled
Microline Mode There are three
Microline modes M50, M50 Plus, OKI
ML192 M50
Cash Drawer Time The cash drawer fire
time is adjustable in the
Ithaca emulation. 10 to 250 Ms 250 Ms
Cash Drawer Sense The sense of the cash
drawer open status can
be reversed. Normal,
Inverted Normal
External User Store Flag for user store in use
or configurable. If the
user store is in use and
has data in it, it can not
be reconfigured. In use or configurable. Not Settable.
Electronic Journal This specifies the
amount of external flash
available for the
electronic journal or user
data space. 1 to 31 64K blocks 2
External User Store This indicates the
amount of external flash
that is available for user
storage (Graphics and
characters.) 1 to 31 64K Blocks This is not settable. It
equals 32 – the
Electronic Journal
setting.
EJ Manual Print This sets whether or not
the manual electronic
journal options are
available. Enabled
Disabled Enabled
EJ Record Numbers This options sets
weather or not the
record number is printed
with journal entries. Enabled
Disabled Enabled
User Store This option sets a lock
on user store that
prevents any changes to
the data. Unlocked
Locked Unlocked
On/Off Switch This option disables the
On/Off switch Enabled
Disabled Enabled
Audio Alert This option configures
the operation of the
audio alert Off, 50 ms to 1 Second
in 50 mSec steps 250 mS
Cutter Option This activates or
deactivates the auto
cutter Active
Inactive Active if the printer is
equipped with an auto
cutter.
Pre-Cut Feed or Tear
Point Adjust This option sets how
much the cut point is
adjusted before the auto
cut or manual tear-off. 0 or none to 20 mm. 0
Cutter Speed This option adjusts the
auto cutter speed to
allow the use of thicker
paper. 130 to 80 where 80 is
the slowest speed. 100
Note: There are other features that may be configurable. It is intended
that if you need to change them, you will contact TransAct Technical
support for assistance.