TransAct Technologies ITHERM 280 User Manual
Page 281
iTherm
®
280 Programmer’s Guide
ITherm® 280 Unicode and Fonts
28-07764
Rev C
Page 279
NOTE: This is the minimum spacing. If the character height setting
requires a larger spacing, the character height will override this setting.
Function
Set stroke font brush size.
All
ASCII
[ESC] + B
Hexadecimal 1BH 2BH 42H
Decimal
<27> <43> <66>
Range
w = 0, 6 – 200
Description The [ESC] + B command will set brush stroke percentage for stroke fonts. If the
brush size is set to zero the font design stroke width will be used.
Values from 6 to 200 represent 0.4 to 12% of the em-width of the font. The default for most
fonts is about 3%. The ITherm 280 using the GB18030 font supplied by TransAct Technologies
produces the best characters with a brush size of about 100.
Note: The default value for the Brush stroke may be set in the POR.INI file.
[ESC] [ P
Set character pitch (Legacy mode command)
PcOS
ASCII
[ESC] [ P
Hexadecimal 1BH 5BH 50H
Decimal
<27> <91> <80>
IPCL
&%F1, &%F2, &%F3, &%F4, &%F5, &%F6, &%F7
EPOS
[ESC] [SP]
Description The [ESC] [ P
printer resolution limits the exact print pitch. The following table lists the exact
pitch for various values on
Resulting
Characters
per Inch
IPCL
1
1.00
2
2.00
3
3.01
4
4.00
5
4.95
6
5.94
7
6.93
8
8.00
&%F7
9
9.04
10
9.90
&%F3
11
10.95
12
12.23
&%F2
13
13.00
14
13.87
15
14.86
&%F6
Resulting
Characters
per Inch
IPCL
16
16.00
17
17.33
&%F1
18
17.33
19
18.91
20
20.8
&%F5
21
20.8
22
23.11
23
23.11
24
23.11
&%F4
25
23.11
26
26
27
26
28
26
29
29.71
30
29.71
Table 51 Character Pitch