TransAct Technologies ITHERM 280 - Manual (Page 185)

iTherm ® 280 Programmer’s Guide Programming Codes
28-07764 Rev C Page 183
Supported TM-T88 Commands
Print and Feed Commands
Command Name Page
LF 0AH Print and line feed 191
CR 0DH Print and carriage return 191
ESC d 1BH,64H Print and feed lines 191
ESC J 1BH,4AH Print and feed paper vertical units 192
Line Spacing Commands
Command Name Page
ESC 2 1BH,32H Select default line spacing, 1/6 lpi 193
ESC 3 1BH,33H Set line spacing 193
Character Commands
Command Name Page
ESC SP 1BH,20H Set right-side character spacing 193
ESC ! 1BH,21H Select print mode(s) 199
ESC % 1BH,25H Select/cancel user-defined character sets 193
ESC & 1BH,26H Define user-defined characters 194
ESC - 1BH,2DH Turn underline mode on/off 199
ESC ? 1BH,3FH Cancel user-defined characters 194
ESC E 1BH,45H Turn emphasized mode on/off 199
ESC G 1BH,47H Turn double-strike mode on/off 200
ESC M 1BH,4DH Select character font 194
ESC R 1BH,52H Select an international character set 195
ESC V 1BH,56H Turn on/off 90
°
rotation mode 200
ESC t 1BH,74H Select character code table 198
ESC { 1BH,7BH Turn upside-down printing mode on/off 200
GS ! 1DH,21H Select character size 201
GS B 1DH,42H Turn white/black reverse printing mode on/off 198
Panel Button Commands
Command Name Page
ESC c 5 1BH,63H,
35H Enable/disable panel buttons 202
Paper Sensor Commands
Command Name Page
ESC c 4 1BH,63H,
34H Select paper sensor(s) to stop printing 203
ESC c 3 1BH,63H,
33H Select paper sensor(s) to output paper out
signals 204