TransAct Technologies ITHERM 280 - Manual (Page 114)

Programming Codes iTherm ® 280 Programmer’s Guide
Page 112 Rev C 28-07764
[ESC] % G Begin italics
ASCII
[ESC] % G
Hexadecimal 1BH 25H 47H
Decimal
<27> <37> <71>
IPCL &%MI
EPOS [ESC] 4
Description The [ESC] % G command begins italic print mode.
Note: Italics are not available in all print modes.
[ESC] % H End italics
ASCII
[ESC] % H
Hexadecimal 1BH 25H 48H
Decimal
<27> <37> <72>
IPCL &%CI
EPOS [ESC] 5
Description The [ESC] % H command ends italic print mode.