TANDBERG 6000MXP - Manual (Page 82)

82
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
H323Gatekeeper Avaya AnnexH:
Set AnnexH to On to enable Avaya strongest level of encryption (H.235.5 with Avaya extensions). When set to Off, the Avaya CM needs to have a “green
license” installed to support non-encrypted endpoints.
Example: xconfiguration h323gatekeeper avaya annexh: off
H323Gatekeeper Avaya MultipointCount: <0..9>
The Avaya MultipointCount decides how many simultaneous calls the endpoint will be able to handle. If it is non-zero, that value will be used (there is a
maximum to what the Avaya CM can handle depending on its software version. Change this value only if you know what you’re doing). If set to “0”, default
safe values will be used. The default safe values are:
4 if AnnexH is turned on.
6 if AnnexH is turned off.
NOTE: The multipointcount setting is only used when in an Avaya environment.
Example: xconfiguration h323gatekeeper avaya multipointcount: 0
H323Gatekeeper Avaya Password:
The Avaya password is a hidden write-only parameter that sets the PIN code to use for AnnexH encryption.
Example: xconfiguration h323gatekeeper avaya password: 123
H323Gatekeeper MultipleAlias:
If set to On, the system will register multiple H.323-IDs on the Gatekeeper based on the values of the parameters: System Name, International Name and H.323 ID.
Up to 3 aliases are possible.
If set to Off, the system will register a single H.323-IDs on the Gatekeeper based on the following priority:
H.323 ID 1.
International Name 2.
System Name 3.
Example: xconfiguration h323gatekeeper multiplealias: On
H323Gatekeeper Authentication Mode:
If Authentication Mode is set to Auto and the gatekeeper indicates that it requires authentication, the endpoint will automatically try to authenticate itself to the
Gatekeeper.
If Authentication Mode is set to Off the system will not try to authenticate itself to a Gatekeeper, but will still try a normal registration.
Example: xconfiguration h323gatekeeper authentication mode: auto
H323Gatekeeper Authentication ID:
The system sends the Authentication ID and Password to a Gatekeeper for authentication. The authentication is a one way authentication from the endpoint
system to a Gatekeeper, i.e. the endpoint is authenticated to the Gatekeeper. If the Gatekeeper indicates that no authentication is required, the endpoint will
still try to register.
Example: xconfiguration h323gatekeeper authentication id: TANDBERG
H323Gatekeeper
cont...