TANDBERG 6000MXP - Manual (Page 81)

81
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
G703 Interface MaxChannels: <1..30/23>
Indicates the maximum number of channels the codec is allowed to use on the E1/T1 interface.
When E1 is selected, maximum is 30 channels. When T1 is selected, maximum is 24 channels.
Example: xconfiguration g703 interface maxchannels: 12
H320 NetType:
NetType: (Codec 3000)
NetType: (Codec 3000NET)
Defines the network type to use for H.320 calls.
Example: xconfiguration h320 nettype: bri
H323 Mode:
Enables/disables the possibility to place and receive H.323 calls.
Example: xconfiguration h323 mode: on
H323CallSetup Mode:
Defines how to establish H.323 calls.
Direct: An IP-address must be used in order to make a H.323 call. The system will not use a gatekeeper or CallManager.
Gatekeeper: The system will use a gatekeeper to make a H.323 call.
CallManager: The system will use a CallManager to make a H.323 call.
NOTE! Direct H.323calls can be made even though the H323CallSetup Mode is set to Gatekeeper or Callmanager.
Example: xConfiguration h323callsetup mode: gatekeeper
H323Gatekeeper Discovery:
Auto: The system will automatically try to register to any available gatekeeper. If a gatekeeper responds to the request sent from the codec within 30 seconds this specific gate-
keeper will be used. This requires auto discovery on the gatekeeper as well. If no gatekeeper responds, the system will not use a gatekeeper for making H.323 calls and hence
an IP-address must be specified manually.
Manual: The system will use a specific gatekeeper identified by H323Gatekeeper Address.
Example: xconfiguration h323gatekeeper discovery: manual
H323Gatekeeper Address:
Specifies the address of the gatekeeper to use if Discovery is set to Manual.
Example: xconfiguration h323gatekeeper address: 10.47.9.1
H323Gatekeeper Avaya Mode:
NOTE: The Mode setting is the main switch to the rest of the options. If Mode is set to Off the other Avaya options will be ignored by the system.
Set to On when the specified gatekeeper (xconfiguration H323Gatekeeper Address) is an Avaya gatekeeper. This enables Avaya-specific behaviour. An
Avaya gatekeeper is called Avaya Communication Manager - Avaya CM for short).
Example: xconfiguration h323gatekeeper avaya mode: off
G703
cont...
— H323Gatekeeper