TANDBERG 6000MXP - Manual (Page 185)

185
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Status Information – xstatus /xstatus.xml
D 13887.08
MAY 2008
Status information followed by a
*
will not be shown unless Detailed Level has been set to 2 – see XACLI – Special commands – xpreferences
Conference (type = Idle / PointToPoint / PointToMultiSite / MultiSite ):
If type = Idle the following will be included:
Example:
*s Conference (type=Idle): /
*s/end
If type = PointToPoint the following will be included:
Calls:
CallRef [1..11]: 1..11
DuoVideo (status = None / Ready / On ):
If status = None / Ready the following will be included:
If status = On the following will be included:
CallRef [1..11]: 0..11
LoudestParticipant:
CallRef: 0..11
Example:
*s Conference (type=PointToPoint):
Calls:
CallRef 1: 1
DuoVideo (status=Ready): /
LoudestParticipant:
CallRef: 1
*s/end
If type = PointToMultiSite the following will be included:
Calls:
CallRef [1..11]: 1..11
DuoVideo (status = None / Ready / On ):
If status = None / Ready the following will be included:
Conference