TANDBERG 6000MXP - Manual (Page 154)

154
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an (r) appended to the parameter name. The (r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Command Description Parameters Result parameters
when OK
Result parameters
when error
Example
DisconnectCall Command used to
disconnect a call. Call: <1..11>
Reference to the call to be
disconnected. If this parameter is
omitted, all active calls in the system
will be disconnected. None As above xcommand disconnectcall call:9
*r Result (status=OK):
*r/end
OK
DuoVideoStart Command used to
initiate DuoVideo/H.239
from the system. VideoSource: <1..6>
Specifies which video source to be
used for the additional video stream.
If this parameter is omitted, the
system will use the default DuoVideo
source configured for the system,
ref. configuration DuoVideoSource None As above xcommand duovideostart videosource:5
*r Result (status=OK):
*r/end
OK
DuoVideoStop Command used to stop
DuoVideo/H.239. None None As above xcommand duovideostop
*r Result (status=OK):
*r/end
OK
DTMFSend Command used to send
DTMF tones to the far
end.
NOTE! The DTMF tones
are also played back
locally.
NOTE! This command
is also supported when
the system is not in a
call (the tones will only
be played back locally).
Value (r) :
The DTMF tone to send.
None As above xcommand dtmfsend value:5
*r Result (status=OK):
*r/end
OK
FECCFocus Command used to
change focus of a far
end camera. Value (r) : <+/->
Specifies whether to increase or
decrease focus.
None As above xcommand feccfocus value:+
*r Result (status=OK):
*r/end
OK
DisconnectCall — FECCFocus