Pictureprogram [1, Presentationstart: Page 105: Tandberg 3000, Reference guide for system integrators, Pictureprogram, Presentationstart packetlossdownspeed, Cont
Page 105: Tandberg 3000, Reference guide for system integrators, Pictureprogram, Presentationstart packetlossdownspeed, Cont
105
TANDBERG 3000
MXP
&
6000
MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
OSD
Icon
Warning:
Enables/Disables the Warning icon.
Example:
xconfiguration osd icon warning: on
OSD
MCUStatusLine
Mode:
If set to On the MultiSite / MCU / DuoVideo indicators will be displayed and provide information about the conference.
If set to Off the MultiSite / MCU / DuoVideo indicators will not be displayed.
If set to Auto the MultiSite / MCU / DuoVideo indicators will be displayed for a few seconds and then timed out. When grabbing the remote control, the
indicators will be shown again.
Example:
xconfiguration osd mcustatusline mode: on
OSD
Offset
Mode:
Set Offset Mode to On to add extra margins for the on screen menu. If you experience problems viewing all text or buttons on the screen you can try to
set Offset Mode to On. This problem can occur on some 720p screens.
Example:
xconfiguration osd offset mode: off
PictureProgram [1..4]
Layout:
Example:
xconfiguration pictureprogram 1 layout: full
The Picture Programs are used
to define custom picture layouts
to be displayed locally.
PictureProgram [1..4]
Window [1..6]
Picture:
Example:
xconfiguration pictureprogram 1 window 2 picture: localmain
PictureProgram [1..4]
Window [1..6]
Call: <1..11>
Example:
xconfiguration pictureprogram 1 window 2 call: 4
PresentationStart:
If set to Auto, the Dual Stream is started automatically when a presentation is initiated from the menu or directly from the remote control
(requires that the system has Presenter option installed and the far end side also supports Dual Stream).
If set to Manual, the Dual Stream must be started manually.
Example:
xconfiguration presentationstart: auto
PacketlossDownSpeed
Mode:
If set to Auto, the system will attempt to downspeed the video channel from the sender by sending flowcontrol messages if packet loss is encountered.
If set to Off, the system will not request downspeeding based on packetloss.
Example:
xconfiguration packetlossdownspeed mode: auto
OSD
cont...
— PacketLossDownspeed