TANDBERG 6000MXP - Manual (Page 177)

177
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Status Information – xstatus /xstatus.xml
D 13887.08
MAY 2008
Status information followed by a
*
will not be shown unless Detailed Level has been set to 2 – see XACLI – Special commands – xpreferences
If status = Dialing / Alerting / Proceeding / EstablOut / EstablIn / AwaitInCnf / Connected / Disconnecting / Await2ndnr / ClearOut / ClearIn / Syncing / Capex / Synced / Unframed
and type = Vtlph
and protocol = H323 / SIP
and direction = Incoming / Outgoing
and logTag = x
the following will be included:
CallRate: 64 / 128 / .. / 4096
RemoteNumber:
RemoteSubAddress:
IncomingNumber:
Appears for incoming calls only
IncomingSubAddress:
Mute: On / Off
Microphone: On / Off
Duration: 0...
MuteOutgoing: On / Off
Channels [1..2] (type = Incoming / Outgoing ):
If type = Incoming / Outgoing the following will be included:
Rate: 64 / .. / 4096
Restrict: On / Off
Encryption (status = Off / Negotiate / On ):
If status = Off / Negotiate the following will be included:
If status = On the following will be included:
Type: DES / AES-128
CheckCode:
Audio (status = Active / Inactive ):
If status = Inactive the following will be included:
Call
cont...