TANDBERG 6000MXP - Manual (Page 144)

144
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an (r) appended to the parameter name. The (r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Command Description Parameters Result parameters
when OK
Result parameters
when error
Example
CallSetAudioTP Command used with
TANDBERG Experia.
Call (r) : <1..11>
Mode (r) :
None As above xcommand callsetaudiotp call:2 mode:on
*r Result (status=OK):
*r/end
OK
CameraFocus Command used to
change focus of a spe-
cific camera.
Camera (r) : <1..13>
Addresses which camera to have its
focus changed.
Value (r) :
Specifies the wanted operation.
None As above xcommand camerafocus camera:1 value:+
*r Result (status=OK):
*r/end
OK
CameraForceUpgrade Command used to
initiate software
upgarde of the
TANDBERG Precision HD
Camera. Should only be
used after
downgrade
of the TANDBERG
MXP Codec software
or if the configuration
CameraSwUpgrade is
set to Off. When the
TANDBERG MXP Codec
software is upgraded,
the TANDBERG Precision
HD Camera will be
upgraded automatically
if the configuration
CameraSwUpgrade is
set to Auto.
Camera (r) : <1..13> None As above xcommand cameraforceupgrade camera:1
*r Result (status=OK):
*r/end
OK
CameraHalt Command used to stop
moving a specific
camera. None None As above xcommand camerahalt
*r Result (status=OK):
*r/end
OK
CameraFocus — CameraHalt