TANDBERG 6000MXP - Manual (Page 111)

111
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
SerialPort [1] Direct Buffer: <0..16384> NOTE! Port 1 Only
Specifies the size of the buffer used in direct mode. Try setting this value higher if you need a continuous stream of data on the receiving end. Higher
values introduces more delay.
Example: xconfiguration serialport 1 direct buffer: 5120
SerialPort [1..2] BaudRate: <1200/2400/4800/9600/19200/38400/57600/115200>
Specify the baud rate on a serial port.
Example: xconfiguration serialport 1 baudrate: 9600
SerialPort [1..2] Parity:
Specify the Parity on a Serial Port
Example: xconfiguration serialport 1 parity: odd
SerialPort [1..2] DataBits: <7/8>
Specify the number of databits on a Serial Port
Example: txconfiguration serialport 1 databits: 7
SerialPort [1..2] StopBits: <1/2>
Specify the number of stopbits on a Serial Port
Example: xconfiguration serialport 1 stopbits: 2
SIP Mode:
On: Setting the SIP mode to on will enable the system for incoming and outgoing SIP calls.
Off: Setting the SIP mode to off will disable incoming and outgoing SIP calls from the system.
Example: xconfiguration sip mode: on
SIP ReplyTo URI:
If configured it is this URI that will be displayed in the call lists.
Example: xconfiguration sip replyto uri:
SIP Server Discovery:
Manual: When Manual is selected, the manually configured SIP Server address will be used
Auto: When Auto is selected, the SIP Server address is obtained using Dynamic Host Configuration Protocol (DHCP).
Example: xconfiguration sip server discovery: manual
SIP Server Address:
The Server Address is the manually configured address for the outbound proxy and registrar. It is possible to use a fully qualified domain name, or an IP
address. The default port is 5060 for TCP and UDP, but another one can be provided
Example: xconfiguration sip server address:
SerialPort
cont...
— SIP