TANDBERG 6000MXP - Manual (Page 163)

163
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Command Information
D 13887.08
MAY 2008
Required parameters are identified by an (r) appended to the parameter name. The (r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Command Description Parameters Result parameters
when OK
Result parameters
when error
Example
SPIDAutoConfigure Command used to
initiate automatic
configuration of SPIDs. None None As above xcommand spidautoconfigure
*r Result (status=OK):
*r/end
OK
StillImageSend Command used to send
a still image. VideoSource: <1..6>
Specifies from which video source to
send a still image. If this parameter
is omitted, the system will use the
default still image source configured
for the system. None As above xcommand stillimagesend videosource:5
*r Result (status=OK):
*r/end
OK
StreamingStart Command used to start
streaming from the
system. None None As above xcommand streamingstart
*r Result (status=OK):
*r/end
OK
StreamingStop Command used to stop
streaming from the
system. None None As above xcommand streamingstop
*r Result (status=OK):
*r/end
OK
TextDelete Command used to
delete a text line added
by the TextDisplay
command. Layer (r) : <1..3>
The layer to delete.
None As above xcommand textdelete layer:1
*r Result (status=OK):
*r/end
OK
TextDisplay Command used add a
text line on screen. Layer (r) : <1..3>
Defines the lines position.
Text:
The text to display.
TimeOut: <0..999>
Sets the timeout value for the text
line.
None As above xcommand textdisplay layer:1 text:TAND-
BERG timeout:100
*r Result (status=OK):
*r/end
OK
SPIDAutoConfigure — TextDisplay