TANDBERG 6000MXP - Manual (Page 59)

59 D 13887.08
MAY 2008
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
A command of great importance, xpreferences lets the
user/control application individually configure the Telnet/
RS 232 session in use. When parsing data sent from the co-
dec using a control system it is important to set preferences
to match the parser in use.
The xpreferences is a session specific command, i.e.
different RS 232/Telnet sessions can define preferences
individually. This also implies that the preferences must be
set each time the control application connects to the codec,
i.e. the control application should always set the necessary
preferences when connecting to the system (or after system
reboot when using RS 232).
The xpreferences Options
xpreferences ?
usage: xpreferences xpathwrite
or: xpreferences detaillevel <1..2>
or: xpreferences xmlconfigfeedback
or: xpreferences xmlstatusfeedback
or: xpreferences xmlcommandresult
or: xpreferences itemnumber
or: xpreferences completepath
OK
XACLI – Special Commands – xpreferences (I)
About the TANDBERG API
About xpreferences xpreferences xpathwrite
xpreferences xpathwrite
Disables/enables the XPath search engine when issuing con-
figurations. When the XPath search engine is disabled, the
user/control application must supply the complete path to
the configurations to be set (no “double slashes” allowed).
This will improve the performance of the system when issu-
ing many consecutive configurations.
NOTE! It is always recommended to supply the complete
path for configurations to be set when issuing commands
from an external control application.
xpreferences detaillevel
xpreferences detaillevel <1..2>
Most information elements accessible by the status-type
commands are defined to be level 1 information. However
there are some information elements defined to be level 2
information. When reading status information, only the infor-
mation elements with a detail level equal to or less than the
detaillevel defined for the interface will be listed.
The detaillevel is by default set to 1 when connecting to an
RS 232/Telnet session.
xpreferences xmlconfigfeedback
If xmlconfigfeedback is set to on, feedback on configura-
tions will be returned in XML-format instead of the standard
XACLI configuration format.
EXAMPLE
XACLI-format:
*c xConfiguration SerialPort 1 BaudRate: 2400
XML format
2400
xpreferences xmlconfigfeedback
xpreferences xmlcommandresult
If xmlcommandresult is set to on, response for commands
will be returned in XML-format.
EXAMPLE
XACLI-format:
xcom dial 10.47.15.127
*r Result (status=OK):
CallRef: 1
LogTag: 8
*r/end
XML format
xcom dial 10.47.15.127
1
8
xpreferences xmlcommandresult