Startupvideosource: <0/1/2/3/4/5/6, Stillimagesource: <0/1/2/3/4/5/6, Startupvideosource stillimagesource ssh – TANDBERG 6000MXP User Manual
Page 113: Startupvideosource — ssh
113
TANDBERG 3000
MXP
&
6000
MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
SNMP
SystemContact:
Defines the SNMP system contact.
Example:
xconfiguration snmp systemcontact:
SNMP
SystemLocation:
Defines the SNMP system location.
Example:
xconfiguration snmp systemlocation:
SNMP
HostIPAddr [1..3]:
Defines SNMP host addresses.
Example:
xconfiguration snmp hostipaddr:
StartupVideoSource: <0/1/2/3/4/5/6>
Defines the video source the system will use as default after a reboot, and after the system goes out from screensaver mode.
If set to 0, the system will use the video source that was selected before reboot.
Example:
xconfiguration startupvideosource: 1
StillImageSource: <0/1/2/3/4/5/6>
Defines the default still image source. If set to 0, the system will use the current main video source as still image source.
Example:
xconfiguration stillimagesource: 4
SSH
Mode:
If set to Off, it will not be possible to connect to the system using SSH. The Command Line Interface can be accessed using SSH (Secure Shell), which allows for secure control
of the TANDBERG MXP.
Example: xconfiguration SSH Mode: On
StartupVideoSource — SSH