Call, Tandberg 3000, Xhistor – TANDBERG 6000MXP User Manual
Page 213
213
TANDBERG 3000
MXP
&
6000
MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
D 13887.08
MAY 2008
Status information followed by a
*
will not be shown unless Detailed Level has been set to 2
–
see
XACLI – Special commands – xpreferences
Call [1..20]
type =
NA
/
Tlph
/
Vtlph
protocol =
NA
/
ISDN
/
H320
/
H323
/
SIP
direction =
NA
/
Incoming
/
Outgoing
If type =
NA
and protocol =
NA
and direction =
NA
the following will be included:
If type =
Tlph / Vtlph
and protocol =
ISDN / H320 /H323 / SIP
and direction =
Incoming / Outgoing
the following will be included:
LogTag:
1
RemoteNumber:
EncryptionIn:
Off/DES/AES-128
EncryptionOut:
Off/DES/AES-128
CallRate:
DisconnectCauseValue*:
DisconnectCause*:
Duration:
UptimeAtEndOfCall:
BillingCode:
Audio**:
PacketsReceived, PacketsLost, PacketsDropped, DurationLossLevel1, DurationJitterLevel1, NumberOfLevel1Bursts, DurationLossLevel2, DurationJitterLevel2, NumberOfLevel2Bursts
Video**:
PacketsReceived, PacketsLost, PacketsDropped, DurationLossLevel1, DurationJitterLevel1, NumberOfLevel1Bursts, DurationLossLevel2, DurationJitterLevel2, NumberOfLevel2Bursts
* Disconnect Cause Overview
The
DisconnectCause
indicates the reason why the call was disconnected. See
for an overview of the disconnect causes.
The
DisconnectCauseValue
contains additional information to the DisconnectCause. See
for an overview of the disconnect cause values.
** Packet Loss Levels
Level 1: Packet loss > 5% and Jitter > 100ms
Level 2: Packet loss > 10% and Jitter > 200ms
Status Information – xhistory / xhistory.xml
Call