TANDBERG 6000MXP - Manual (Page 73)

73
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
CameraSwUpgrade:
If set to Auto the Camera software will be automatically upgraded by the codec. If set to Off, camera software upgrade must be initiated manually by the command
CameraForceUpgrade .
NOTE! If codec software is downgraded the camera software must be downgraded manually by the command CameraForceUpgrade . Applies to TANDBERG Precision HD camera only!
Example: xconfiguration cameraswupgrade: Auto
CameraTracking Speed:
Sets the camera tracking speed. Camera tracking is enabled/disabled by the commands
CameraTrackingStart and CameraTrackingStop .
Example: xconfiguration cameratracking speed: normal
Conference DefaultCall CallRate: Max/Auto>
Defines the default call rate to use when placing calls from the system.
NOTE! The supported call rates will depend on product type and software options.
NOTE! Auto: 384 kbps on ISDN/768 kbps on LAN
Example: xconfiguration conference defaultcall callrate: 320
The DefaultCall settings specify
call properties to use if proper-
ties are not specified directly
when placing the call.
Conference DefaultCall Restrict:
A restricted call uses 56kbps channels rather than the default unrestricted 64kbps channels. Some older networks
(primarily in the USA) do not support 64kbps channels and require the use of restricted 56kbps calls. By default, the
system will dial an unrestricted call and downspeed to 56kbps if necessary.
To force a restricted call, choose Restrict (56k) On.
Example: xconfiguration conference defaultcall restrict: off
Conference DefaultCall NetProfile: <1..7>
Selects default NetProfile. Please refer to the
NetProfile configuration for further details on the supported NetProfiles.
Example: xconfiguration conference defaultcall netprofile: 3
Conference H323Alias E164:
Defines the E164 alias for the system. Valid characters are 0-9,
* and #.
Example: xconfiguration conference h323alias e164: 666666
The aliases define the telephone
numbers for the unit, i.e. num-
bers to call to reach the unit.
The system can register both an
E164 alias, which can only con-
tain digits (including
* , #) and
an ID, which can also contain
letters.
Conference H323Alias ID:
Defines the H323Alias ID for the system. If no ID is specified the system will use the SystemUnit Name as
H323Alias ID.
Example: xconfiguration conference h323alias id: MyH323AliasId
Conference PeriodicIntra: <0..1000>
Use this setting to generate a new intra frame with a configurable interval. Use this setting with caution since it in a normal network will de-
crease the video quality. The default value is set to 0 which means off. If you configure it to 10 it will send an intra every 10th second.
Example: xconfiguration conference periodicintra: 0
CameraSwUpgrade — Conference