TANDBERG 6000MXP - Manual (Page 114)

114
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
Streaming
Streaming Port: <0..65534>
Specifies the port, which the codec shall stream to. If several codec’s are streaming to the same IP-address, different ports have to be used
in order for the client to know which stream to receive. If the first codec streams on port 2240 and the second codec on port 2250, the cli-
ent has to specify which port to listen to. Video is transmitted on the specified port; audio is transmitted on the port number 4 greater than
the specified video port, in this case 2244 and 2254.
Example: xconfiguration streaming port: 2240
You can stream in a MCU call
for systems with MS installed.
Streaming will count as 1 site.
However, you cannot stream
when Dual Stream/H.239 is
activated.
Dual Stream = Tandberg
specific method of sending Dual
Images.
H.239 = ITU ratified way of
sending Dual Images.
TANDBERG uses Dual Stream to
cover both these two technolo-
gies.
Streaming Hops: <0..255>
Number of router hops you want the codec to stream to. The default value 1 will normally allow the streaming data to pass one router.
Example: xconfiguration streaming hops: 1
Streaming Address:
The address, which you want the codec to stream to. This address could be a multicast address, broadcast address or a unicast address.
Example: xconfiguration streaming address:
Streaming VideoRate: <16/32/64/128/192/256/320>
Selects the video rate in kbps to stream out on the network.
Example: xconfiguration streaming videorate: 128
Streaming Announcements:
Turn On or Off Streaming Announcement Protocol.
Example: xconfiguration streaming announcements: on
Streaming Source:
Select streaming source as Local, Remote or Auto. If set to Auto the streaming will be voice switched. The site currently speaking will be
streamed.
Example: xconfiguration streaming source: auto
Streaming Password:
Streaming password. This password and the ip password will give access to the streaming page in he internal web browser. By using this
password the more sensitive ip password can be reserved to the administrator.
Example: xconfiguration streaming password: xxx
Streaming Quality:
When set to Motion the video is optimized for smooth motion video.
When set to Sharpness the video is optimized for sharp video.
Example: xconfiguration streaming quality: motion
Streaming AllowRemoteStart:
If set to Off, streaming can only be started locally from the menu interface or from the dataport (RS-232). If set to On, streaming can also be
started from the Web interface, the XML interface and from Telnet.
Example: xconfiguration streaming allowremotestart: off
See comment on previous page