Remote contacts, 4 programming operation record position – Omega RD200 User Manual
Page 95
－９１－
10
13. REMOTE CONTACTS
13.4 Programming Operation Record Position
This explanation is only for the remote contacts (option).
Press and simultaneously for 3 seconds or
more to display the “Operation printing position”
programming screen. Printing Nos. are A, B, C and D. The
default values are A = 20, B = 40, C = 60 and D = 80.
1
Operation Record
The programmed recording positions are recorded by
the plotter pen. When the contact signal is shorted, the
recording position shifts to 5 mm to the right from the
programmed operation record position. The record Nos.
(A to D) are also recorded at a fixed interval.
2
Programming Mode
3
Programming Flow Chart
Operation screen
[Check]
（ ＋ ）
3 sec. or more
[To be ready for programming]
[Selecting printing No.]
→
[Programming printing position]
Temporarily stored
Programming other channels?
＋
Stored
For operation record, the “Terminal
Allocation for Operation”, allocations of
record Nos. (A to D) to terminal Nos.
(EX 1 to EX 4), is necessary. See
Section 13.2.
Press or to change
record Nos. record positions can be
checked.
Record position is programmable from
10% to 90% of the printing range.
Error is displayed when the
programmed value is between 0%
and 9% or between 91% and 99%.
Store the [temporarily stored]
parameters into memory. (Programming
change mark is printed.)
Record No.
Record position
Cursor
Printing No.
YES
NO
Printing No.
Ref. 1
Ref. 2
Ref. 4
Printing
position
Printing position
The terminal allocation
is necessary.
Remarks
Record position range
Error display
Record No.
Operation record lines and Nos.
90(%
Programming range
5mm
5mm
A
B
Record line when
the contact is open
If any error occurs, press
any key other
than .
Ref. 3
0
CLEAR
2
TAG
DISP
0
CLEAR
2
TAG
SET
END
%
/
°F
4
SCALE
0
CLEAR
ENTRY
SHIFT
SHIFT
SET
END
/
%
Storing
Reference 4
Other speed No. check
Reference 1
Reference 2
Reference 3
Record line when the
contact is shorted