Omega RD200 - Manual (Page 74)

－７０－
11. OTHER PROGRAMMING 11.8 Engineering Units
3
Programming Flow Chart
From PPM to G/MIN in CH 3
Operation screen
[Check]
＋
  
[To be ready for programming]
 
[Programming channel]
  
[ Programming engineering unit
character ]
,
  
Temporarily stored
Programming other channels?
＋
Stored
(1) Select the channel to be “none” with
or .*
(2) Press and
simultaneously to clear and perform
[temporarily stored] and then [stored].
* If the channel is programmed by a
numeric value and cleared, the
engineering unit of channel before
programming change is programmed
to be “none”.
• Press or to change
channels.
• The digit displaying an engineering
unit character (digit No. with decimal
point) shifts with or .
• Numeric value (0 to 9):
to , and
• Alphabetic characters (A to Z):
Press and
simultaneously and select a character
by pressing or .
• Special characters (%, /, °C, °F)
% ( + )
/ ( + )
°C ( + )*
°F ( + )*
*A space corresponding to 2 digits is used.
• (space): A space is treated as
a character.
These engineering units are treated as
a printing unit only. They are not
treated as computing units.
Store the [temporarily stored]
parameters into the memory. (A
programming change mark is printed.)
Various keys
Channel
Cursor
YES
NO
Channel
Remarks
Decimal point
To check all
programmed digits
Reference 1
Engineering
unit character
% /
°C °F
SHIFT
SHIFT
SHIFT
SHIFT
0
CLEAR
9
LIST
－
(-)
SHIFT
6
A～Z
% /
%
/
°C
°F
SPACE
COPY(=)
DISP
SHIFT
3
UNIT
SET
END
3
UNIT
°F
ENTRY
SHIFT SET
END
Storing Reference 4
% /
SHIFT
0
CLEAR
To program engineering unit
to “none”
Remarks
Programmable characters
and key operation
Reference 2
°C, °F engineering unit
Reference 3
Ref. 1
Ref. 2
Ref. 4
Engineering
unit character
Engineering
unit character