Omega RD200 - Manual (Page 94)

－９０－
The “3 chart speeds” programming screen appears only in the remote contacts (option).
Press and simultaneously to display the “3 chart speeds” programming screen. Program 3 chart
speeds (CS1 to 3) and select the desired speed with a contact signal. See section 13.1
2 .
3
Programming Mode
 
4
Programming Flow Chart
From 20 mm/h to 40 mm/h for CS2
Operation screen
[Check]
＋
  
[To be ready for programming]
  
[Selecting CS No.]
→
  
[Selecting speed]
  
Error display appears?
Temporarily stored
Programming other Nos.?
＋
Stored
13. REMOTE CONTACTS 13.3 Programming 3 Chart Speeds

Speed
No.
Chart speed
(4 digits programming)
Cursor Unit for the
speed
Cursor
YES
Speed No.
YES
NO
Ref. 1
Ref. 2
Ref. 3
Speed unit
NO
Default: 20 (RD200), 25 (RD2800)
Programming range: 0001 to 0600
(mm/h) or 0001 to 0200 (mm/min.)
0000mm/h can be set for RD2800.
When 0000mm/h is set, chart is fed at
the speed of 12.5mm/h.
Defaults parameters and
programming range
All printings except time line, digital
data printing and programming
change mark will not be executed.
See Section 10.1.
If the chart speed is
programmed at 151 mm/h
or faster;
Remarks 1
SHIFT
1
CHART
DISP
SHIFT
1
CHART
SET
END
% /
°F
0
CLEAR
4
SCALE
0
CLEAR
0
CLEAR
ENTRY
Any key other
than
SHIFT
SHIFT
SET
END
Press or to change CS
No. Chart speeds can be checked.
Other speed No. check Reference 1
/ %
If the chart speed is changed, the
parameters programmed in the
[Periodic data printing] (Section 11.7)
is cleared
.
Influence to periodic
data printing
Remarks 2
Place the cursor on the character
display (left digit) and press or
to switch [M] and [H] alternately.
Changing the speed
unit (h/min.)
/
%
Reference 2
Store the [temporarily stored] parameters
into memory. (Programming change mark
is printed.)
Storing Reference 3
Speed No.