Adjustment, 1 adjustment of measured values – Omega RD200 User Manual
Page 110
－１０６－
18. ADJUSTMENT
18.1 Adjustment of Measured Values
4
Programming Flow Chart
Operation screen
[Engineering mode selection]
（ ＋ ）
3 sec. or more
[Selecting adjustment]
→
[Selecting measured value]
→
[Programming channel]
[To zero adjustment display]
[Zero adjustment]
Apply an input equivalent to the minimum value with a standard tool.
[To span adjustment display]
(Computation of zero
correction data)
[Span adjustment]
Apply an input equivalent to the maximum value with a standard tool.
[To programming channel
screen]
(Computation of span
correction data)
＋
Stored
Computed correction data are
canceled if the screen is returned to
the operation screen in the procedures
before [Storing].
When a skipped channel is
programmed, operation is not
accepted.
Change the connection to other input
terminals to be adjusted and repeat
the same procedure from the
programming channel screen
(indicated by a dotted line).
In zero adjustment or span adjustment
screen, when and are
pressed simultaneously and then
is pressed, the correction data of its
channel are initialized.
: Memory clear
: Adjustment
: Hardware check
: Measured value adjustment
: Shift programming for
measured value
: Printing position adjustment
: Time-axis adjustment for pens
Store the computed correction data
into memory.
Cursor Adjustment
Cursor
Measured value
Cursor
Channel
Cursor
Minimum value
Maximum value
(Zero)
(Span)
Channel
Cursor
Ref. 1
Ref. 2
Ref. 3
Remarks 2
Remarks 3
2 sec.
or more
Remarks 1
By returning to the operation
screen
Remarks 1
Skipped channel does not
accept any [ENTRY] key
Other channels adjustment
Initialization of correction data
Engineering mode types
Reference 1
Adjustment types
Storing
DISP
SHIFT
6
A -Z
°C
°F
ENTRY
°F
°C
ENTRY
1
CHART
ENTRY
ENTRY
ENTRY
SHIFT
SET
END
ENTRY
SHIFT
0
CLEAR
ENTRY
Remarks 2
Remarks 3
Reference 2
Reference 3
Remarks 4