Omega RD200 - Manual (Page 91)

－８７－
13. REMOTE CONTACTS 13.1 Remote Contacts Function
This explanation is only for the remote contacts (option).
1
Remote Contacts
(1) The following functions are available with the contact
signals at remote contacts terminals (EX1 to 4). However,
the functions are limited due to four terminals (EX1 to 4)
provided. Moreover, some functions are automatically
allocated to a certain terminal Nos.
(2) Programming to allocate the functions to terminal Nos. is
necessary.
Functions Terminals Remarks
(1) Printing on/off and selection of three chart
speeds
2 terminals (EX1, EX2) Programming 3 speeds, See Section 13.3. (Note 1)
(2) Execution of message printing (No.1 to 5) 4 terminals (EX1 to EX4) Programming message, See Section 11.10. (Note 2)
(3) Execution of message printing (No.1 and 2) 2 terminals (EX1, EX2) Programming message, See Section 11.10. (Note 3)
(4) Execution of digital data printing Any 1 terminal
(5) Execution of list printing (list 1, 2, 3) Any 3 terminals
(6) Execution of operation record (No.A to D) Any 4 terminals Programming operation record, See Section 13.4.
(7) Reset of totallization Any 1 terminal Available in totalization (option)
(Note 1) Free terminals left are EX3 and EX4.
(Note 2) No free terminals are left.
(Note 3) Free terminals left are EX3 and EX4.
2
Functions and Terminal Contact Signals
Functions Contact signal at terminal
• Program 3 chart speeds first. See Section 13.3.
With
COM Printing on/off and selection
of 3 hart speeds
EX1 EX2
CS1 OFF OFF
CS2 ON OFF Printing: On
CS3 OFF ON
Printing: Off ON ON
(1) Printing on/off and selection of
3 chart speeds
(Note) Program “Printing on/off” to on with a key operation in advance.
• Program messages first. See Section 11.10.
With COM Messag
e EX1 EX2 EX3 EX4*
No.1 OFF OFF OFF For trigger
No.2 ON OFF OFF
No.3 OFF ON OFF
No.4 ON ON OFF
No.5 OFF OFF ON
(2) Execution of message printing
(No. 1 to 5)
* When the trigger signals is sent (for 1 sec. or more) after selecting the
message No., the printing of programmed message starts.
(Note) Program “Printing on/off” to on with a key operation in advance.
Execution of message printing with key operation is also available.
See Section 9.4.
Remote contacts terminals
ON: Short OFF: Open
COM EX1 EX2 EX3 EX4
1 sec. or more