Omega RD200 - Manual (Page 85)

－８１－
12. ALARM OUTPUT 12.1 Alarm Output Programming Items
This explanation is only for the alarm output (option). The alarm output programming is necessary after
programming the “alarm”.
1
Programming Items for Alarm Output
1) Relay No.
Setting of the relay No. where the alarm information (activation/reset) of each alarm point is
to be output. Set them to each alarm point.
2) Output wiring
Setting to AND or OR for each relay No.. When one relay is used by multiple alarm points,
you can select AND or OR for the output wiring.
(1) Relay coil phase: Setting whether N and O terminals are shorted (Energized) or opened
(Non-energized) when an alarm activates.
(2) Relay output latch: Setting whether the alarm status is to be continued until is
pressed (Hold) even if the alarm becomes reset condition, or it is reset (Not hold) at the
same time as resetting of the alarm.
3) Output mode
(3) Alarm display * latch: Setting whether the alarm display is kept displayed until is
pressed (Hold) even if the alarm becomes reset condition or turned off (Not hold) at the
same time as resetting of the alarm.
* Alarm display: ALARM status lamp
2
Details of Programming Items
1) Relay No. and default values
Alarm *
Alarm point Alarm type Relay No.
Level 1 ０
Level 2 ０
Level 3 ０
CH 1
Level 4 ０
Level 1 ０
Level 2 ０
Level 3 ０
CH 2
2 to 4-pen
types only
Level 4 ０
Level 1 ０
Level 2 ０
Level 3 ０
CH 3
3 and 4-pen
types only
Level 4 ０
Level 1 ０
Level 2 ０
Level 3 ０
CH 4
4-pen type
only
Level 4 ０
FAiL ０
C. End ０
*This is the “Alarm” programming. The relay No. is
fixed at 0 in the standard specifications (AH is fixed
at 00). 1 to n (Note) should be set only when alarm
output (option) is added. (0 means no output.)
(Note) n: 6 or 12 depending on the number of output
points.
RD200: 6 only
2) AND/OR, output mode and default values
Output Mode
Relay
No.
AND/
OR
Relay coil
phase
Relay
output
latch
Alarm
display
latch
RLy1 or
RLy2 or
RLy3 or
RLy4 or
RLy5 or
RLy6 or
RLy7 or
RLy8 or
RLy9 or
RLy10 or
RLy11 or
RLy12 or
Energized
Common
to all
relays
Not hold
Common
to all
relays
Not hold
Common
to all
displays
* RD200: Relay No. is 1 to 6.
RD2800: it is variable depending on the number
of output points (Rel;ay No. is 1 to 12 for
12-point outputs.).
ENTRY
ENTRY