Omega RD200 - Manual (Page 73)

－６９－
11. OTHER PROGRAMMING 11.8 Engineering Units
Engineering units up to 5 digits can be assigned for digital data printing and scale printing.
Press and simultaneously to display [Engineering unit] programming screen.
(Digital data printing) (Scale printing) (List printing)
1
In case no engineering unit is programmed;
An engineering unit is decided by the range number programmed in the [Range/Printing range] programming.
Voltage range Temperature range
mV
(01 to 05)
V
(06 to 10)
°C
(Nos. other than ones
shown on the right)
K
(47, 80)
2
Programming Mode
  
*1: Engineering unit character
The character at the digit where the digit number is pointed by the cursor is displayed.
*2: Digit No. of engineering unit character
A digit No. 1 to 5 is displayed by pressing .
Press and simultaneously to clear the digit No. and press for reprogramming a
new digit No.
A programmed engineering unit is deleted and
the engineering unit determined by the range
No. is displayed If the scale is cleared in a channel; the
engineering unit of this channel is deleted, and it
becomes the engineering unit determined by
range No.

*1
単位印字の例 Examples of engineering unit printing
If clear is stored at scale programming;
If the range No. is changed;
SHIFT
3
UNIT
°F
°F
°F SHIFT
0
CLEAR
Engin
eeri
n
g
un
it c
h
a
ra
ct
e
r
Digit No. of engineering unit character *2
(Up to 5 digits.)
(Fixed)
(Numeric numbers (1 to 5) appear for the digit not programmed by pressing .)
Ch
an
ne
l
Cur
so
r