Omega RD200 - Manual (Page 101)

－９７－
14. PRINTING FORMAT 14.3 Programming Zone Printing
3
Programming Flow Chart (RD200)
Programming CH 1 and CH 3 to zone No.1, and
CH 2 and CH 4 to zone No. 2
+
     
     
（3 time） →
 
→
  
  
  
+
Press to display parameters.
The parameters are displayed
sequentially each time is
pressed.
Store the parameters into memory.
(Programming change mark is
printed.)
“+” mark is printed at the border of the
area.
*Fill unused digits with spaces
.
Cursor
Standard
Ref. 1
Zone
(1)
(2)
(3)
(4)
(5)
(6)
Cursor
DISP
SHIFT DISP
SET
END
ºF
ENTRY
ENTRY
∗
∗
ENTRY
SHIFT
SET
END
ENTRY
ENTRY
Operation screen
[Checking printing format]
[To be ready for programming]
[Selecting zone printing]
[Programming channel of 1st area]
[To display step (4)]
Stored
Press any key other than
and program again. When it is normal,
the next screen appears. SHIFT
Selection and
overlapping of channels
Remarks 3
The channel not selected in any
zone is skipped. Also, if the selection
of channel is overlapped or the
skipped channel is selected, error
display appears.
Checking parameters Reference 1
Storing Reference 2
Border mark Reference 3
[Programming channel of 2nd area]
Remarks 1
Remarks 1
Remarks 2
Ref. 2
Remedial measure
to error display
Various
keys
Various
keys
Remarks 1
For storing parameters into memory,
return the screen to Step (4).
Return to the screen of Step (4) Remarks 2