Omega RD200 - Manual (Page 49)

－４５－
9. PRINTINGS 9.1 Printing Types and the Details
Printing comprises trace printing and digital printing. The fixed-time printing and trace printing are executed even if
any operation is not programmed.
1
Printing Types and the Details
Printing type Printing details Remarks
Trend printing is executed for each pen (channel)
1st pen 2nd pen 3rd pen 4th pen
Red Green Blue Brown
Trace printing
(Cartridge pen)
⎯
Fixed-time
printing
The following details are printed on the fixed time.
(1) Year/Month/Day (2) Time (3) Time line (4) Chart speed (5) Scale, Engineering unit, Tag
10-1
Periodic
data printing
Measured values are printed on the trace printing with programmed intervals. The
printing starts from the programmed start time line. The printing mode is different
depending on chart speed.
11-7
Digital data
printing
Measured values are printed on the trace printing. The printing mode is different
depending on chart speed.
9-2
List 1
printing
Major parameters (Range/Printing range, Scale, Subtract printing, Periodic data
printing) are printed as a table.
9-3
List 2
printing
The parameters (such as time axis synchronizing, message, items relating to
options) other than those involved in List 1 are printed as a table.
9-3
List 3
printing
All parameters (List 1 + List 2) are printed as a table. 9-3
Message
printing
Message is printed on the right side of the chart paper by selecting the
programmed message No.
9-4
Alarm
printing
Alarm details (time, alarm points, alarm type) are printed on the right side of the
chart paper when an alarm activates or an alarm is reset.
10-4
Time axis
sync. mark
printing
(1) When the time axis synchronization (POC) is switched on or off, its time, mark
(*), and ON or OFF are printed on the right side of the chart paper.
(2) When it is ON, a mark (*) is printed to the right of the time print of fixed-time
printing.
9-6
10-1
Power-on
printing
Year/Month/Day and time are printed on the left side of the chart paper when the
power is turned on.
6-1
Operation
printing line
and
Operation
printing No.
For the remote contacts (option), it is required to program the "Operation printing
position" and select one of Act 1 to 4 in the "Remote contacts" programming.
(1) Printing line: When a contact signal (on) is applied to the allocated terminal,
the line is printed by 5 mm to the right of the programmed printing line
position.
(2) Operation printing No.: Operation printing No. (A to D) is printed at constant
intervals to the left of the programmed printing line position.
13-4
D
igi
ta
l D
a
ta
Pr
in
ting
(P
lo
tt
e
r
pen)
Printer
check
printing
When hardware check is executed by selecting the printer (plotter pen)
characters are printed for checking purpose.
19-2