Omega RD200 - Manual (Page 41)

－３７－
7. PROGRAMMING 7.4 Programming Procedures
This section explains the basic programming parameters.
1
Basic of Programming Flow Chart
Operation screen
( Measured value/clock/alarm )
Programmed parameter check
Ready for programming
Programming
by using numeric values or
parameters selection
Same programming for all
channels?
Temporarily stored
Programming other channels?
Stored
Use [copy] function for convenient operation.
See Section 11. 14.
Programming is interrupted to return to the operation
screen at any programming stage by pressing
key before storing.
Keys to be pressed depending on programming items.
This action is necessary for some programming items.
For parameters to be programmed for each channel,
check the programmed parameters of other channels
with or .
(1) Programming lamp lights.
(2) The cursor appears at a
programmable digit.
If this procedure is omitted, programmed parameters
are not stored into memory.
(Note) Common programmed parameters are
stored only by pressing key.
(1) Memory colon starts blinking.
(2) Programming change mark is printed.*
Programmed parameter (including temporarily
stored programmed parameters) are stored.
During this storing operation, measurement is
interrupted.
* The change mark is printed on the right side of chart
paper. However the mark will not be printed
completely until the chart paper advances several
lines.
2
Key Operation
1) Numeric keys and cursor
• Cursor shifts rightward when pressing numeric
keys ( to and ).
• Press or for moving the cursor.
2) How to add or delete a decimal point
• To add the decimal point move the cursor to
and press . To delete the
decimal point, press . (Numeric vallue is
also deleted.)
3) Clearing a displayed programmed parameter
• The programmed parameter is cleared by
pressing and simultaneously .
（ ＋ ）
YES
NO
NO
YES
(Programming for
each channel)
Reference
+
(Note)
3 sec. or
more

Memory colon
Programming lamp
Character display (Abbreviation
of a programming item) Char
ac
ter
dis
p
lay

Cursor
Programming same parameter to
other channels
Reference
DISP
DISP
SET
END
Function
keys
ENTRY
ENTRY
SET
END
SHIFT
% /
ENTRY
0
CLEAR
9
LIST
－
(-)
°C °F SPACE
COPY(=)
SHIFT
0
CLEAR
CLOCK