Omega RD200 - Manual (Page 35)

－３１－
6. BASIC OPERATION 6.5 Switching Operation Screen (RD2800)
For RD2800, two operation screens, (1) measured value screen and (2) alarm activation screen, are available.
Each time is pressed, the screen switches. Bargraphs for analog indications are displayed in any of
these screens.
Measured value screen
Alarm activation
screen
(Note) The alarm activation screen is only available when an alarm activates (shown by dotted lines). When no
alarm activates, the measured value screen only appears even if is pressed.
1 Measured value screen
The screen below is for 4-pen type. 1-pen type - measured value is displayed in CH 1. 2-pen type - measured
values are displayed in CH 1 and CH 2. 3-pen type - measured values are displayed in CH 1 to CH 3.
2 Alarm activation screen
This screen is only available when an alarm activates.
In each channel, the alarm level 1, 2, 3 and 4
are allocated to the digits from the left end. The
alarm type shall be displayed only at the digit
where an alarm activates.
For alarm types, see Section 11.5, item
1 .
Alarm type at level 1
Alarm type at level 2
Alarm type at level 3
Alarm type at level 4
Explanation for the display
DISP
DISP DISP
DISP
Ch 1 Ch 2 Ch 3 Ch 4 Time Chart speed