Omega RD200 - Manual (Page 77)

－７３－
11. OTHER PROGRAMMING 11.10 Message
Messages are printed from (1) key operation or (2) remote contacts signal*. A message up to 15 digits and 5
different messages (No.1 to No. 5) can be programmed. Press and simultaneously for 3 seconds
or more to display the [Message] programming screen.
* This function is only available in the remote
contacts (option). See Section 13.1.
1
Programming Mode
Note) The default is no programming of messages. The following figure is an example of 8-digit message
programmed for No.1.
   
*1: Massage character
The character at the digit where the digit number is pointed by the cursor is displayed.
*2: Digit No. of message character
A digit No. 1 to 15 is displayed by pressing .
Press and simultaneously to clear the digit No. and press for reprogramming a
new digit No.
Example of message printing

Mess
ag
e
ch
a
racter
*1
0
CLEAR
6
A～Z
°F
Digit No. of message character *2
(Up to 15 digits.)
(Fixed)
(Numeric numbers (1 to 15) appear for the digit not programmed by pressing .)
No.
(1 to 5)
Cu
rso
r
°F
°F SHIFT
0
CLEAR