Omega RD200 - Manual (Page 66)

－６２－
11. OTHER PROGRAMMING 11.4 Subtract Printing
3
Programming Flow Chart
Printing [Channel 1 – Channel 2] at Channel 3 within a printing range of
±250
Operation screen
[Check]
＋
 
[To be ready for programming]
 
[ Programming channel for subtract
printing ]
 
[Programming equal]
＋
 
[Programming reference channel]
  
[ Programming subtraction channel ]
→
  
[To Mode 2]

[ Programming subtract printing
range ]
 
Error message appears?
Temporarily sotred
Programming other channels?
＋
Stored
You can check the range
programming (including subtract
printing) of other channels.
Press or to change
channels..
If a specified value (reference value) is
programmed instead of the subtraction
channel in the flow chart, the
difference with the reference value will
be printed. Add a decimal point to the
reference value.
•Programming “to”: +
•Decimal point: in the next digit
•Deletion of decimal point: in
the next digit
Store the [temporarily stored]
parameters into the memory. (A
programming change mark is printed.)
* Fill unused digits with spaces.
Channel
Cursor
Channel
YES
Subtract printing range
∗
NO
YES
NO
Cursor
Reference channel
Subtraction
channel Minus
Reference
channel
DISP
SHIFT
7
RANGE
SET
END
3
UNIT
SHIFT
/
1
CHART
－
(-)
2
TAG
ENTRY
ENTRY
SHIFT
SET
END
SHIFT
－
(-)
・
CLOCK
SPACE
COPY(=)
Storing Reference 3
Subtraction
channel
Subtract printing
channel
Other channels check Reference 1
Programming reference channel
and subtraction channel
Reference 2
Various keys Reference 3
Various
keys
Any key other
than
SHIFT
Ref. 1
Ref. 2
Ref. 3
Ref. 4
/ %