5 notes on using this product, Important – Renesas R0E530640MCU00 User Manual

Page 222

R0E530640MCU00 User’s Manual

7. Hardware Specifications

REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 222 of 229

7.5 Notes on Using This Product

Notes on using this product are listed below. When debugging the MCU using the emulator, be careful about the following
precautions.

IMPORTANT

Note on the Version of the Emulator Debugger:

Be sure to use this product with the following emulator debugger.

- M16C R8C E100 Emulator debugger V.1.00 Release 00 or later

Notes on Downloading Firmware:

Before using this product for the first time, it is necessary to download the dedicated firmware (emulator’s

control software installed in the flash memory in the E100). If you need to download at debugger startup, a
message will appear. Download the firmware following the message.

Do not shut off the power while downloading the firmware. If this happens, the product will not start up

properly. If the power is shut off unexpectedly, redownload the firmware.

Download the firmware with the user system not connected.

Notes on Self-check:

If the self-check does not result normally (excluding user system errors), the product may be damaged. Then

contact your local distributor.

Run the self-check with the user system not connected.

Note on Quitting the Emulator Debugger:

To restart the emulator debugger, always shut off the emulator power supply and then turn on it again.

Note on Display of MCU Status:

"MCU status" you can refer to in the MCU tab of the MCU Setting dialog box of the emulator debugger shows

pin levels of the user system. Make sure that proper pin levels are specified according to the mode you use.

Note on Processor Mode Register 0:

Do not set the BCLK output disable bit (PM07) to “1b” (not output). If you set to it, the internal clock in the

evaluation MCU stops and the emulator cannot operate normally.

This manual is related to the following products:

M16C/64