Renesas R0E530640MCU00 - Manual (Page 22)

R0E530640MCU00 User’s Manual 2. Setup
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 22 of 229
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figures 2.1 and 2.2. For details, refer to each section hereafter. If the
emulator does not start up normally, refer to “6. Troubleshooting (Action on Error)” (page 211).
1 Check the package components. Refer to “1.1 Package Components” (page 16).
▼
2 User registration Refer to “User Registration” (page 14).
▼
3 Install the included software, etc. Install them from the included CD-ROM.
▼
4
Connect the MCU unit to the E100 main
unit.
Refer to “2.3 Connecting/Disconnecting the MCU Unit to/from the
E100 Emulator Main Unit” (page 25)
▼
5 Connect the host machine.
Connect the USB interface connector of the emulator and the USB
port of the host machine.
▼
6 Connect the emulator power supply. Connect an emulator power supply to the power connector.
▼
7 Turn on the power supply. Turn ON the power to the emulator.
▼
8 Check the LED display of the emulator.
Check that the system status LED is lighting. When the user system
is not connected, the POWER LED does not light up.
▼
9
Try to use the emulator debugger according
to the tutorial.
When using the emulator debugger for the first time, try to use the
emulator functions, referring to “3. Tutorial” (page 36).
If the emulator debugger does not start, follow steps 10 through 13
in this chart to perform a self-check.
▼
10
Create a project in the High-performance
Embedded Workshop.
Start up the High-performance Embedded Workshop and create a
project by following “4. Preparing to Debug” (page 67).
▼
11
Start up the emulator debugger from the
High-performance Embedded Workshop.
Start up the High-performance Embedded Workshop to launch the
emulator debugger by following “4. Preparing to Debug” (page 67).
▼
12 Set up the target MCU and system.
Set Device Setting dialog box of the emulator debugger and check
“Start booting up on successful completion of self checking” by
following “4. Preparing to Debug” (page 67).
▼
13 Execute self-check
Figure 2.1 Flowchart of starting up the emulator (For the first time)