Ricoh Aficio Copy Machine 180 - Manual (Page 260)

Configuring LPR Port Printing
25
2
Configuring LPR Port Printing
This section explains the procedure for printing to a LPR port from Windows
NT.
Preparation
The TCP/IP protocols must be installed and configured correctly. Refer to
P.16 “Preparing to Use the TCP/IP Protocol for Printing”, for more information.
Note
❒ The following instructions assume that the printer drivers have already been
installed. This is a procedure to change the printer port to LPR.
A
Click [Start] , point to [Settings] , and then click [Printers] .
B
Select the icon of the printer you want to use by clicking it. On the [File]
menu, click [Properties] .
C
Click the [Ports] tab, and then click [Add Port] .
D
In the [Available Printer Ports] box, select [LPR Port] by clicking it, and then
click [New Port] .
Note
❒ If “LPR Port” does not appear, “Microsoft TCP/IP Printing” has not been
installed.
E
Input the IP address of the Network Interface Board into the [Name or ad-
dress of server providing lpd] box.
F
Input “lp” into the [Name of printer or print queue on that server] box, and click
[OK] .
G
Click [Close] .
H
Confirm that the port name is displayed in the [print to the following port(s)]
box and the ' mark is inside the check box. And then click [OK] .