NEC Server 140Rc-4 - Manual (Page 94)

3-22 Setting Up Your Server
Removal Procedure
More than one person should remove the server from the rack.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
■
Do not lift the server only by a single person.
■
Do not pinch your finger with mechanical components.
■
Note high temperature.
■
Do not pull out a device from the rack if the rack is unstable.
■
Do not leave more than one device being pulled out from the rack.
1. After confirming that the server is off-powered, remove the power cords and all interface
cables connected to the server.
2. Loosen two screws with which the cable arm is fixed to the rear of the server to remove
the cable arm from the server.
3. Release the security lock to remove the front bezel.
Screws
Cable arm