NEC Server 140Rc-4 - Manual (Page 75)

Setting Up Your Server 3-3
SELECTING A SITE
Installation
Your server unit should be mounted in a standard EIA 19-inch rack cabinet.
Installation of Rack
Refer to the documentation attached to the rack or contact your service representative for rack
installation of the server unit.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-
3 to 1-8 for details.
■
Do not use the server in any unapproved place.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-8 for details.
■
Do not carry or install the server only by a single person.
■
Do not install the server where the load may be concentrated on a specific
point.
■
Do not install any component on the server only by a single person.
■
Do not pull out a device from the rack if the rack is unstable.
■
Do not leave more than one device being pulled out from the rack.
■
Do not provide the wiring exceeding the rating power.