NEC Server 140Rc-4 - Manual (Page 254)

8-16 Troubleshooting
Error
code
Error message Recommended Action
02D0 System cache error - Cache disabled. The cache cannot be used. Contact your
service representative.
02D1 System Memory exceeds the CPU's caching
limit.
02F5 DMA Test Failed.
02F6 Software NMI Failed.
02F7 Fail-safe Timer NMI Failed.
Contact your service representative.
0500 Expansion ROM not initialized - PCI Slot 01
0501 Expansion ROM not initialized - PCI Slot 02
0502 Expansion ROM not initialized - PCI Slot 03
0503 Expansion ROM not initialized - PCI Slot 04
0504 Expansion ROM not initialized - PCI Slot 05
0505 Expansion ROM not initialized - PCI Slot 06
0506 Expansion ROM not initialized - PCI Slot 07
0507 Expansion ROM not initialized - PCI Slot 08
0611 IDE configuration changed.
0613 COM A configuration changed.
0614 COM A config. error - device disabled.
0615 COM B configuration changed. Contact your service representative.
0616 COM B config. error - device disabled.
0617 Floppy configuration changed.
0618 Floppy config. error - device disabled.
0619 Parallel port configuration changed.
061A Parallel port config. error - device disabled.
0B00 Rebooted during BIOS boot at Post Code.
0B1B PCI System Error on Bus/Device/Function.
0B1C PCI Parity Error on Bus/Device/Function.
0B28 Unsupported Processor detected on
Processor 1.
0B29 Unsupported Processor detected on
Processor 2.
0B2A Unsupported Processor detected on
Processor 3.
0B2B Unsupported Processor detected on
Processor 4.
Make sure that the server supports the CPU.
If you are not sure, contact your service
representative to request the maintenance.
0B30 Fan 1 Alarm occurred.
0B31 Fan 2 Alarm occurred.
0B32 Fan 3 Alarm occurred.
0B33 Fan 4 Alarm occurred.
0B34 Fan 5 Alarm occurred.
0B35 Fan 6 Alarm occurred.
A fan failure or fan clogging may occur.
Contact your service representative to
request the maintenance.