NEC Server 140Rc-4 - Manual (Page 147)

Configuring Your Server 4-37
Exiting the Utility
To exit the utility, press Esc until a message prompts you to exit (if you changed any setting, you are
prompted to save the changes before you exit).
Configure/View Host Adapter Settings
The Configure/View Host Adapter Settings has the following menu items and parameters. Read
descriptions to select a correct parameter for each menu item.
Configuration
SCSI Bus Interface Definitions
SCSI Controller ID -------------------------------------------
7
SCSI Controller Parity --------------------------------------- Enabled
SCSI Controller Termination ------------------------------- Automatic
Additional Options
Boot Device Configuration ---------------------------------
Press
SCSI Device Configuration---------------------------------- Press
Advanced Configuration ------------------------------------ Press
- Reset to Host Adapter Defaults
SCSI Bus Interface Definitions
To set three menu items under "SCSI Bus Interface Definitions", select a menu item with the cursor
keys (↓ or ↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection.
The following table lists menu items, available parameters, and descriptions.
Menu item Parameter Description
SCSI Controller ID 0 - [7] - 15 Select "7".
SCSI Controller Parity [Enabled]
Disabled Select "Enabled".
SCSI Controller
Termination [Enabled]
Disabled Enable or disable the SCSI termination.
Select "Enabled".
[ ]: Factory-set