NEC Server 140Rc-4 - Manual (Page 255)

Troubleshooting 8-17
Error
code
Error message Recommended Action
0B50 Processor #1 with error taken off line.
0B51 Processor #2 with error taken offline.
0B52 Processor #3 with error taken offline.
0B53 Processor #4 with error taken offline.
The CPU is degraded. Contact your
service representative.
0B5F Forced to use Processor with error Because an error is detected in every CPU,
the system is forcibly started. Contact your
service representative.
0B60 DIMM group #1 has been disabled
0B61 DIMM group #2 has been disabled
0B62 DIMM group #3 has been disabled
Contact your service representative.
0B70 The error occurred during temperature sensor
reading. Contact your service representative.
0B71 System Temperature out of the range. A fan failure or fan clogging may occur.
Contact your service representative to
request the maintenance.
0B74 The error occurred during voltage sensor
reading.
0B75 System voltage out of the range.
0B78 The error occurred during fan sensor reading
Contact your service representative.
0B7C The error occurred during redundant power
module confirmation Contact you service representative to
replace the power supply unit.
0B7D The normal operation can't be guaranteed with
use of only one PSU Contact you service representative to add an
additional power supply unit or replace the
existing power supply unit.
0B80 BMC Memory Test Failed.
0B81 BMC Firmware Code Area CRC check failed.
0B82 BMC core hardware failure.
0B83 BMC IBF or OBF check failed.
0B8A BMC SEL area full.
0B8B BMC progress check timeout.
0B8C BMC command access failed.
0B8D Could not redirect the console - BMC Busy -
0B8E Could not redirect the console - BMC Error -
0B8F Could not redirect the console - BMC
Parameter Error -
0B90 BMC Platform Information Area corrupted.
0B91 BMC update firmware corrupted.
Turn off the power once and then on again to
start the server. If the error cannot be
corrected, contact your service
representative.
0B92 Internal Use Area of BMC FRU corrupted. All the commands and functions other than
the FRU command and the EMP function
can be used. This is not a fatal error. Turn
off the power once and then on again to
restart the server. If the error cannot be
corrected, contact your service
representative.
0B93 BMC SDR Repository empty. Turn off the power once and then on again to
restart the server. If the error cannot be
corrected, contact your service
representative.