NEC Server 140Rc-4 - Manual (Page 256)

8-18 Troubleshooting
Error
code
Error message Recommended Action
0B94 IPMB signal lines do not respond. All the functions other than the function of
accessing to SMC through IPMB can be used.
This is not a fatal error. Turn off the power
once and then on again to restart the server. If
the error cannot be corrected, contact your
service representative.
0B95 BMC FRU device failure. All the commands and functions other than the
FRU command and the EMP function can be
used. This is not a fatal error. Turn off the
power once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
0B9A BMC not responding.
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
Turn off the power once and then on again to
start the server. If the error cannot be
corrected, contact your service representative.
0BB0 SMBIOS - SROM data read error.
0BB1 SMBIOS - SROM data checksum bad.
Contact your service representative.
0BC0 POST detected startup failure of 1st
Processor.
0BC1 POST detected startup failure of 2nd
Processor.
Contact your service representative to replace
the CPU.
0BD0 1st SMBus address not acknowledged.
0BD1 1st SMBus device Error detected.
0BD2 1st SMBus timeout.
0BD3 2nd SMBus address not acknowledged.
0BD4 2nd SMBus device Error detected.
0BD5 2nd SMBus timeout.
0BD6 3rd SMBus address not acknowledged.
0BD7 3rd SMBus device Error detected.
0BD8 3rd SMBus timeout.
Contact your service representative to replace
the board specified in the system event log.
0BD9 4th SMBus address not acknowledged.
0BDA 4th SMBus device Error detected.
0BDB 4th SMBus timeout.
0BDC 5th SMBus address not acknowledged.
0BDD 5th SMBus device Error detected.
0BDE 5th SMBus timeout.
Contact your service representative to replace
the board specified in the system event log.
0BE8 IPMB address not acknowledged.
0BE9 IPMB device Error detected.
0BEA IPMB timeout.
Contact your service representative.