NEC Server 140Rc-4 - Manual (Page 285)

Troubleshooting 8-47
RESETTING THE SERVER
„ If the server halts before starting the OS, press and hold Ctrl and Alt and press Delete.
This restarts the server.
„
Pressing the RESET switch on the front panel reboots the server.
IMPORTANT: Resetting the server clears the DIMM memory and the
data in process. To reset the server when it is not frozen, make sure
that no processing is in progress.
FORCED SHUTDOWN
Use this function when an OS command does not shut down the server, the POWER switch does not
turn off the server, or resetting does not work.
Press and hold the POWER switch on the server for at least four seconds. The power is forcibly
turned off. To turn on the power back again, wait approximately 10 seconds after turning off the
power (forced shutdown).
IMPORTANT: If the remote power-on function is used, cycle the
power once to load the OS, and turn off the power again in the normal
way.
Press and hold the POWER
switch at least 4 seconds.
RESET switch