NEC Server 140Rc-4 - Manual (Page 53)

General Description 2-19
SCSI Controller
The baseboard includes an embedded Adaptec AIC-7902, which contains two independent channels.
You can enable or disable the SCSI controller in BIOS Setup. Both channels support 16-bit SE or
LVD SCSI operations at the following speeds:
„ Ultra320 (320 MB/sec)
„ Ultra160 (160 MB/sec)
„ Ultra 2 (80 MB/sec)
„ Ultra Wide SE (40 MB/sec)
The baseboard provides active terminators, termination voltage, resettable fuses, and protection
diodes for both SCSI channels. You can disable the onboard terminators in BIOS Setup.
Network Interface Controllers
NOTE: To ensure EMC product regulation compliance, the system
must be used with shielded LAN cables.
The baseboard includes two network interface controllers (NICs):
„
Intel 82550 NIC that supports 10Base-T and 100Base-TX networks
„ Intel 82544 NIC that supports 10Base-T, 100Base-TX networks, and 1000BASE-T
networks
The 82550 controller supports the following features:
„ 32-bit PCI
„ Integrated IEEE 802.3 10Base-T and 100Base-TX compatible PHY
„
IEEE 820.3u auto-negotiation support
„ Chained memory structure similar to the 82559, 82558, 82557 and 82596
„ Full duplex support at both 10 Mbps and 100 Mbps operation
„
Low power +3.3 V device
„ IP checksum off-loading
NIC 1 can be used as both a network interface and server management interface.