NEC Server 140Rc-4 User Manual
Page 263
Troubleshooting 8-25
The keyboard or mouse fails to operate:
T
Is the cable properly connected?
→ Make sure that the cable is connected to the correct connector on the rear of the
server.
→ The keyboard or mouse does not operate if it is connected when the server is
powered (not applicable to USB devices). Power of the server first and connect
it properly.
T
Is BIOS configuration correct?
→ The keyboard and mouse may be disabled with the BIOS setup utility of the server.
Check the settings with the BIOS setup utility.
T
Are the server drivers installed?
→ Refer to the manual that comes with your OS to check that the keyboard and
mouse drivers are installed. (These drivers are installed along with the OS.)
Some OS's allow you to change the keyboard and mouse settings. Refer to
manual that comes with your OS to check that the keyboard and mouse settings
are correct.
T
Is the server in the Secure Mode?
→ In the Secure Mode, the keyboard and mouse are disabled. To release the Secure
Mode, enter the password specified with the BIOS setup utility.
Fail to access (read or write) to the floppy disk:
T
Does the floppy disk drive contain a floppy disk?
→ Insert a floppy disk into the floppy disk drive until it clicks.
T
Is the floppy disk write-protected?
→ Place the write-protect switch on the floppy disk to the "Write-enabled" position.
T
Is the floppy disk formatted?
→ Use a formatted floppy disk or format the floppy disk in the floppy disk drive.
Refer to the manual that comes with the OS for formatting a floppy disk.
T
Is BIOS configuration correct?
→ The floppy disk drive may be disabled with the BIOS setup utility of the server.
Check the setting with the BIOS setup utility.
[Main] - [Legacy Floppy A] [Security] - [Floppy Write Protect]>