Ethernet a modify window, State (boxetherastate), Primaryipaddress (boxetheraprimaryipaddress) – Patton electronic 3120 User Manual
Page 162: Primaryipmask (boxetheraprimaryipmask), Primaryipfilters (boxetheraprimaryipfilters), Secondaryipaddress (boxetherasecondaryipaddress)
12 • Ethernet
Model 3120 RAS Administrators’ Reference Guide
162
Ethernet A Modify Window
Ethernet A Modify Window
This window allows you to make changes to the configuration for Ethernet port A.
To reach this window, select
Modify
from the
Ethernet
main window.
Figure 66. Ethernet Modify Window
State (boxEtherAState)
Indicates the state of the ethernet interface. The following states are valid:
•
notInstalled(0)—Ethernet interface is not physically present
•
noLinkIndication(1)—No cable is connected to ethernet interface. Hub is not seen.
•
adminOff(2)—Ethernet interface has been turned off by setting technique to disable
•
linkIndication10M(3)—Ethernet is 10M
•
linkIndication10Duplex(4)—Ethernet is 10M full duplex
•
linkIndication100M(5)—Ethernet is 100M
•
linkIndication100Duplex(6)—Ethernet is 100M full duplex
PrimaryIPAddress (boxEtherAPrimaryIpAddress)
The Primary ethernet IP address.
PrimaryIpMask (boxEtherAPrimaryIpMask)
The primary ethernet IP subnet mask.
PrimaryIpFilters (boxEtherAPrimaryIpFilters)
Filters packets based on the filters assigned to the Primary IP address of the Ethernet port. Enter the Filter ID
of a filter configured under Filter IP. Separate multiple filters using a comma (,).
SecondaryIpAddress (boxEtherASecondaryIpAddress)
The secondary ethernet IP address.