Patton electronic 3120 - Manual (Page 161)

Ethernet Main Window 161
Model 3120 RAS Administrators’ Reference Guide 12 • Ethernet
• static(1)—Ethernet port is turned on. IP address(es) and mask(s) are obtained from data entered under the
Ethernet link.
Ethernet B
State (boxEtherBState)
Indicates the state of the ethernet interface. The following states are valid:
• notInstalled(0)—Ethernet interface is not physically present
• noLinkIndication(1)—No cable is connected to the Ethernet interface. Hub is not seen.
• adminOff(2)—Ethernet interface has been turned off by setting technique to disable
• linkIndication10M(3)—Ethernet is 10M
• linkIndication10Duplex(4)—Ethernet is 10M full duplex
• linkIndication100M(5)—Ethernet is 100M
• linkIndication100Duplex(6)—Ethernet is 100M full duplex
PrimaryIPAddress (boxEtherBPrimaryIpAddress)
The Primary ethernet IP address.
PrimaryIpMask (boxEtherBPrimaryIpMask)
The primary ethernet IP subnet mask.
SecondaryIpAddress (boxEtherBSecondaryIpAddress)
The secondary ethernet IP address.
Note This address is not propagated via RIP.
SecondaryIpMask (boxEtherBSecondaryIpMask)
The secondary IP ethernet IP subnet mask.
Technique (boxEtherBTechnique)
Turns ethernet port off and on. The remote access server must be reset for this setting to take effect.
• disable(0)—Ethernet port is disabled
• static(1)—Ethernet port is turned on. IP address(es) and mask(s) are obtained from data entered under the
Ethernet link.